DustBubbles are disposable dust collectors for DIY or industrial drills. They use a combination of adhesion to the wall and the action of the drill itself to catch virtually all the dust when you drill.
They make drilling jobs easier - leaving both hands free while
you drill and quicker by saving you the trouble of clearing up afterwards. When you've finished drilling your hole, you simply remove the DustBubble from the wall and discard it along with all the dust.
Industrial specification DustBubbles look like the cost effective trade and DIY Dustbubbles, but the new engineering grade material is tough and heat resistent enough to capture hot metal swarf.
The Contamination Control DustBubble kit is a recognised health and safety tool and was developed specifically to provide cost effective contamination free drilling during building maintenance work.The kit contains 50 strong and heat resistant engineering version of the DustBubbles for DIY and trade, gel wetting agent, secondary bags and a full procedure. For drilling into all types of metal the Engineering DustBubbles are
available separately in packs of 100.
Asbestos, lead-based paint, silica, mold, MDF and metal swarf*
Industrial DustBubbles capture all the debris directly into the bag, there is no further equipment or decontamination neccessary**.
Transparent, flexible & hands free
All DustBubbles are transparent so you can always see where you are drilling. The flexible material allows drilling at an angle or in restrictive spaces and DustBubbles stick to the wall surface so they are hands free for safer drilling.
Tough and heat resistent
DIY DustBubbles are available for ‘Wallpaper & Painted Walls’, ‘Kitchen & Bathroom Tiles’ and ‘Wood (including MDF), Plaster & Untreated Surfaces’; packs of 12 from B&Q (RRP £1.98), multi-packs of 6 from Wilkinson and in trade priced tubes of 1000 or 500. For non-contamination issue maintenance work these offer a hugely cost
effective (from 7p each) protection against dust for general health and safety protection and reduce or eliminate clean up time.
For non contamination control drilling there are just four simple steps to follow: (see side bar)Drilling with the Contamination Control DustBubble Kit is only recommended as part
of an approved health and safety procedure and by a suitable insured operator.
For more information on the DustBubble visit the website
www.dustbubble.co.uk
_______________________________________ |
 Rub the DustBubble between your fingers
to loosen up the
plastic from the label.
Remove the backing
tape & stick firmly to
the wall.
 Pull the label to inflate the DustBubble.
 Push the drill bit through the crosshairs on the label, re-inflate if neccessary & then
drill, keeping the drill bit spinning on withdrawal.
Insert a wallplug through
the DustBubble to seal the hole,wrap your fingers around the bag & pinch carefully off
the wall.
|
|
thepropertycoach
home staging & affordable interior design
© The Property Coach
This website was designed, built and is maintained by Brian Cotsen. Do you need help building & marketing your own website? I tell you all about the books and programmes I used to do it, on my website in the Book Club section.
home | site map | privacy policy | terms & conditions | contact | about me | what is home staging |
|
